Guys, Some time ago, as in 'way back when Moses was a boy', I acquired a Bernard TIG cooler along with a welder I bought. I have only now found a need for it. It is a model 3500SS cooler.

Replacement tig and mig water cooler for 2500SS & 3500SS Bernard cooler is the Nu-Tec® NWC2500 2.4-Gallon (9L). Bernard water cooler replacement. Bernard 3500ss Manual Treadmill In the event confirmed price is higher than listed price, customer may cancel order with no charge. Welding- Direct is not affiliated.

Find replacement parts and receive detailed answers to your questions by downloading owner's manuals for your Miller products.

I believe it's rated for up to 500 amps. A few days ago, I started cleaning it up, and finished the project only today. I blew copious, billowing clouds of black dust out of the radiator fins, then scrubbed the outside with Simple Green, then rinsed with clear water. I then opened the tank.

It had a couple of cups of dried nasty black dusty powder inside the tank. I got the tank squeaky clean then closed it up. After washing, scrubbing, and blowing everything dry with compressed air, I filled the tank with 3 gallons of distilled water. However, upon attempting a test run with none of the lines hooked up to the welder, I was unable to get the pump to deliver any flow. I have found a Bernard manual of sorts on the internet, but it's only about 3 pages long and is short on details. The unit has a TEEL brand rotary vane pump. The pump's intake (suction) hose sticks down through a hole through the top of the tank down into the water reservoir.

It's a straight up lift of not more than 6 inches into the pump. However, it will not deliver any flow. I'm hoping there's some kind of priming sequence that I've overlooked. Because otherwise, I'm thinking perhaps the pump is dead. However, it seems odd that a pump would not deliver so much as a dribble.

The unit certainly sounds smooth enough. There are no odd noises coming from the motor or the pump. Official A Night At The Roxbury Soundtrack Mp3. There are two big 'acorn nuts' on the pump. One of these absolutely looks like an 'acorn'. Thinking that was the one with the inline filter inside, I removed it. However, it was the wrong one. The nut that didn't look so much like an 'acorn' turned out to be the access to the filter screen.

This was not terribly dirty but I got it squeaky clean and reinstalled it. I'm not sure what to do next but am looking forward to receiving lots of bright ideas. Kof 2002 Plus Rom Neo Geo 2017 - Torrent.

If the pump is toast I have a couple of other coolers I can try next. However, I like this one the best. Thanks, Vernon.

I've got a Bernard 3500SS just like that,Well not exactly like that[mine works]. You'll probably have to pull the pump apart and change the rubber impeller.I think Grainger sells TEEL pumps dave [acme thread] Probably best to get a rebuild kit, and change the shaft packing also.Oooohhh. You sure know how to hurt a guy.;o). Thanks for the suggestions. It looks like there may be a few floating around on ebay, too. I guess if I wanted instant gratification I should have gone out and bought a gallon of ice cream.